Hello everybody.
I will try to make it very very simple.
A month ago, I turned on the P-Computer and my steering wheel made its calibration.
But I notice that it does not end as usual, that is to say horizontally.



So I'm looking on the internet, and miles of discussion on drivers and some info on vibrations caused by force feedback. Obviously I checked the drivers, but everything was fine on this side.
So disassembly of the G27 (YouTube tutorials) once inside you remove the parts (1.2.3)



For the rest everything is already written on the following two photos






For me it was actually the 4 screws to tighten. Truck racing almost broke my G27 especially on Bathurst.